What does the "Calibration failed" alarm mean?

Claes Updated by Claes

The "Calibration failed" alarm indicates that the calibration process of your FeedCon device was unsuccessful. This alarm serves as a notification that the FeedCon was unable to complete the calibration procedure for various reasons.

Possible reasons for the "Calibration failed" alarm may include:

  • Lack of connection: The FeedCon may be experiencing a poor network signal or no network connection at all, which can hinder the calibration process.
  • Defective or disconnected motor: The motor responsible for dispensing the feed may be defective or not properly connected, preventing the successful calibration of the FeedCon.
  • Insufficient battery power: The battery powering the FeedCon may not have enough charge to drive the motor during the calibration process, resulting in a failed calibration attempt.

Another possible reason for the calibration failure could be a defect in the FeedCon device itself. In such cases, it is recommended to contact our support team for further assistance and troubleshooting.

To resolve the "Calibration failed" issue, please follow these steps:

  1. Check network connection: Ensure that the FeedCon device has a stable network connection. You can verify this by observing if the FeedCon is blinking green every 5 seconds after encountering the alarm. If it is blinking green every 5 seconds, it indicates that the FeedCon device is connected.
  2. Charge the feeder battery: If the calibration failed due to insufficient battery power, try charging the feeder battery to an adequate level. Make sure to use a compatible charger and follow the manufacturer's guidelines for proper charging.
  3. Contact Nordic Gamekeeper support: If the above steps do not resolve the issue or if you suspect a defect in the FeedCon device, it is recommended to contact our support team. Our dedicated support staff will assist you in diagnosing and resolving the calibration failure.

By following these steps and seeking assistance from our support team if necessary, you can address the "Calibration failed" alarm and ensure proper calibration of your FeedCon device for accurate feed dispensing.

How did we do?

What does the "Battery low" alarm mean?

What does the alarm "Lamp Broken" mean?

Contact